CLONING MODES AND SETTINGS
28
Logicube SuperSonix User’s Manual
MirrorCopy Step-by-Step
1. From within the Settings menu tap
.
2. Select the optional preferences Speed and
Direction and alter them as needed using
their respective icons.
1.
NOTE
: See the Optional
Preference Settings section of
this chapter for more information
on these preference settings.
3. Tap the Percentage icon
to set the
percentage of the Master drive to be
mirrored.
4. A screen will appear asking you to enter a
percentage of the Master drive to clone. Use
the electronic keypad to adjust the value
between 1 and 100% and tap
OK
.
1.
NOTE
: A
User Attention
Required
message will appear
asking: Do you want to set to
XX% mirror copy?
5. Tap
YES
to set the percentage to the
requested value. Tap
NO
to cancel this step
and go back to the previous screen.
6. Tap
(Start) to begin the cloning
process.
7. The Logicube SuperSonix will notify you
when cloning has completed. You will see a
message that reads
Clone Successful!
Drive cloned successfully!
along with the
maximum speed that the transfer process
obtained. Tap and hold down the
STOP
icon
at any time to stop and cancel the cloning
process.
CleverCopy Mode
This mode is recommended for Master drives with
only FAT16, FAT32, or NTFS partitions. It clones all
partitions on the Master drive to the Target drive
and automatically sets the fastest method possible
for each partition.
