DEFAULT PASSWORDS
Logicube ZClone™Xi User’s Manual
84
8.
The following prompt will appear:
New SMB password:
9.
Type the same password you used in step 5 above. The following prompt will appear:
Retype new SMB password:
10.
Type the same password again, then press the Enter key. The Logicube prompt should appear.
11.
Next, to change the “it” password, type the following command then press the Enter key:
sudo passwd it
12.
The following prompt will appear:
Enter new UNIX password:
13.
Type a new password then press the Enter key. The following prompt will appear:
Enter new UNIX password:
14.
Type the new password again then press the Enter key. The following response should appear:
passwd: password updated successfully
15.
Next, type the following command:
sudo smbpasswd it
16.
The following prompt will appear:
New SMB password:
17.
Type the same password you used in step 5 above. The following prompt will appear:
Retype new SMB password:
18.
Type the same password again, then press the Enter key. The Logicube prompt should appear.
19.
Type the following command then press the Enter key:
sudo mount -o remount,ro /
20.
Press the following key combinations to go back to the Graphical User Interface:
Alt+1
10.2 Changing Only the
logicube
Password
For the username: logicube
1.
Connect a USB keyboard to any available USB port of the ZXi then use the following key
combinations:
Alt+2
then
Alt+Shift+Enter
.
2.
Once logicube prompt appears, type the following commands, one line at a time (Press the Enter
key after each command/line):
sudo mount -o remount,rw /
passwd
3.
The following prompt will appear:
