DEFAULT PASSWORDS
Logicube ZClone™Xi User’s Manual
85
Changing password for logicube.
(current) UNIX password:
4.
Type the current password (by default, “logicube” without the quotes) then press the Enter key.
The following prompt will appear:
Enter new UNIX password:
5.
Type a new password then press the Enter key. The following prompt will appear:
Retype new UNIX password:
6.
Type the new password again then press the Enter key. The following response should appear:
passwd: password updated successfully
7.
Next, type the following command:
sudo smbpasswd logicube
8.
The following prompt will appear:
New SMB password:
9.
Type the same password you used in step 5 above. The following prompt will appear:
Retype new SMB password:
10.
Type the same password again, then press the Enter key. The Logicube prompt should appear.
11.
Type the following command then press the Enter key:
sudo mount -o remount,ro /
12.
Press the following key combinations to go back to the Graphical User Interface:
Alt+1
10.3 Changing Only the
it
Password
For the username: it
1.
Connect a USB keyboard to any available USB port of the ZXi then use the following key
combinations:
Alt+2
then
Alt+Shift+Enter
.
2.
Once logicube prompt appears, type the following commands, one line at a time (Press the Enter
key after each command/line):
sudo mount -o remount,rw /
sudo passwd it
3.
The following prompt will appear:
Enter new UNIX password:
4.
Type a new password then press the Enter key. The following prompt will appear:
Enter new UNIX password:
5.
Type the new password again then press the Enter key. The following response should appear:
passwd: password updated successfully
