GETTING STARTED
Logicube ZClone™ User’s Manual
6
Applying power to the ZClone
The ZClone has a power supply located in the back of the device. Attach the included power
cable to the ZClone’s power supply and make sure the switch on the power supply is set to the
‘ON’ position.
The ZClone also has a power button located in the front of the device and is used to turn the
ZClone on and off. When the ZClone is turned on, the power button shows a green light.
Connecting 3.5” Serial ATA (SATA) Drives
The ZClone has hot swappable drive bays located in the front of the unit. There are ten (10) 3.5”
drive bays labeled M1, M2, A1 through A4, and B1 through B4.
Each drive bay is hot swappable and drives can be removed or added as long as there is no activity
on the drives.
1.
Open the drive bay of your choice by gently pulling the release latch.
2.
Carefully swing the drive bay door open all the way to the right.
3.
Insert the 3.5” drive face up (SATA ports should be facing in toward the drive bay) and
push it mostly in. Do not push it in all the way.
4.
To push the SATA drive all the way in, close the drive bay door. You should hear a ‘click’
when the drive bay door is closed all the way.
NOTE:
The drive bay doors have two LEDs. The green LED shows that the drive is connected
and has power. A blinking amber LED should light up showing there is activity on the drive.
This amber LED will light up when you initially connect a drive and will also blink when the
drive is being used for a process (for example cloning or wiping).