GB
9
INSTALLATION
Hose and Cable Lengths
L140WM10E
Coloured
OFF
Underwear
Kidswear
Intensive
Intensive
Wash
Self Clean
Wash Only
Drain + Spin
Rinse + Spin
Drain
Delicates
Synthetics
Wool
Jeans
Quick Wash
Cottons
Child Lock
Function
Delay
Spin Speed
Temp.
Dirt Level
START /
PAUSE
Extra
Low
Low
Mid
High
(°C )
40
30
60
95
1400
1000
600
No
Spin
Extra Rinse
Pre-Wash
PRE-
WASH
CHILD
LOCKED
DOOR
LOCKED
RINSE
SPIN
REMAIN
DELAY
Levelling the Washing Machine
There are 4 levelling feet on the underside. They must be adjusted to make sure the washing machine
is level.
1. On each stand, loosen the lock nut by turning it clockwise with a spanner.
2. Adjust all four feet in this way.
3. Use a spirit level to ensure the washing machine is level.
4. Tighten each lock nut by turning them anti-clockwise (towards the
washing machine body), again using a spanner.
Ensure all four lock nuts are tightened securely. Check the feet are still bolted to the washing machine -
if they’re unbolted, the washing machine will move around.
Water Supply Hose
Points to remember
• Follow the instructions in this section to avoid water leaks.
• Don’t connect the hose to a combination tap.
• Don’t twist, squash, modify or cut the hose.
• Optimum water pressure in the main pipe is 0.02 MPa - 1.0 MPa. If the water pressure is set higher
than this, you will need to install a depressurising valve. Water-flow from the tap should be more
than 5 litres per minute. If you’re unsure, ask a qualified technician to connect the hose.
• This unit must only be connected to cold water mains using the new water inlet hose provided.
Connecting the Water Supply Hose
1. Attach the hose to a tap, and tighten the
plastic joint by hand.
2. Open the tap slowly and check that there
are no leaks around the joint.
The joint is subject to water pressure.
How to connect from the left side
~80cm
~90cm
~85cm
~135cm
min. 60cm
max. 100cm
~40cm
~130cm
How to connect from the right side
3/4”
min. 10 mm
3/4”
min. 10 mm
Plastic
joint
Lock nut
Logik L140WM10E_IB_5L_101011.indb 9
11/10/2010 11:36 AM