GB-11
Battery Installation for the Remote Control
The remote control requires a CR2025, 3V Lithium battery.
1. Slide and hold the battery release tab in the
direction of the arrow.
2. Pull out the battery holder and remove the old
battery.
3. Replace with a new one battery.
4. Insert the battery holder back into the remote
control.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage,
which could cause fire, personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the
battery compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
Removing the Insulating Strip from
the Remote Control
Remove the insulating mylar strip from the
battery if the battery is being used for the first
time. It is located at the bottom back side of the
remote control.
L9SPDVD11_IB_final110322.indd 11
22/03/2011 12:25 PM
Summary of Contents for L9SPDVD11
