10
Programming Your Cooking
Select a cooking mode and temperature before programming. (refer to the "Manual Mode" section on pages
7-8). You do not need to press the Manual button when programming your cooking. Follow the procedure
below.
Programming Cooking Time
You can use this function to set the cooking time.
1. Press the Programming cooking time button two times then press the
or buttons to set the programming hour. Press the Programming
cooking time button again and then press the or buttons to set
minutes if needed.
2. After 5 seconds the oven will set the time automatically. The blue indicator
above will illuminate. Then the oven will start the program in another 5
seconds.
3. The display panel will show the remaining time.
4. When the selected time has elapsed, the oven will stop cooking.
5. You can press the Manual button twice to cancel the program at any time.
Programming Delay Cooking with Cooking Time
You can use this function to delay the cooking time.
1. Set the cooking time using steps 1 and 2 of "Programming cooking time"
section.
2. Press the Programming delay cooking time button two times and
then press the or buttons to set the programming delay cooking hour.
Press the Programming delay cooking time button again then press
the or buttons to set the programming delay cooking minutes if needed.
3. After 5 seconds the oven will set the time automatically. The blue indicators above and will both
illuminate. The display panel will show the time left before cooking will start.
4. When the selected time has elapsed the oven will sound once to start and will stop after the programmed
cooking time.
For example: it is 10:00 am. A cooking time of 1 hour has been programmed, and 15 minutes delayed cooking
has been programmed. The programming will start automatically at 10:15am, and automatically stop at 11:15am.
You could press the Manual button twice to cancel the program at anytime.
Operation in Case of Emergency
In the event of an emergency, you should:
• Switch off the oven and if possible, disconnect it from the mains supply. Make sure all controls are set to the “0”
position or “0” degree.
• Call the service centre
• Some minor faults can be fixed by referring to the instructions given in the table below. Before calling the
customer support centre or the service centre check the following points that are presented in the table.
Problem
Reason
Action
The appliance does not work.
• Break in power supply
• Manual mode is not
selected
• Check the household fuse box, if there is
a blown fuse replace it with a new one.
• Select manual mode
The oven lighting does not work. The bulb is loose or
damaged
Tighten up or replace the bulb. (See
replacement of the oven lamp)
RUN
RUN
LBMULX11_IB_final110520.indd 10
20/05/2011 4:46 PM
