14
Maintenance
Changing the Internal Light
1. Before carrying out the bulb replacement always
adjust the thermostat control dial to Position OFF,
then disconnect the mains supply.
2. Hold and lift up the light bulb cover.
3. Remove the old bulb by unscrewing in an anti-
clockwise direction..
4. Replace with a new bulb (10W SES).
5. Refit the translucent light cover and reconnect the
unit to the mains supply and switch on by adjusting
the thermostat.
Care When Handling / Moving the Unit
Hold the unit around its sides or base when moving it. Under no circumstances should it be lifted by
holding the edges of the top surface.
Servicing
The unit should be serviced by an authorised engineer and only genuine spare parts should be
used. Under no circumstances should you attempt to repair the unit yourself. Repairs carried out by
inexperienced persons may cause injury or serious malfunction. Contact a qualified technician.
Switching Off for Long Periods of Time
When the unit is not in use for a long period of time, disconnect it from the mains supply, empty all food
and clean the unit, leaving the door ajar to prevent unpleasant smells.
Disposal
Old units still have some residual value. An environmentally friendly method of disposal will ensure that
valuable raw materials can be recovered and used again. The refrigerant used in the unit and insulation
materials require special disposal procedures. Ensure that none of the pipes on the back of the unit are
damaged prior to disposal.
Up to date information concerning options of disposing of your old unit and packaging from the new one
can be obtained from your local council office.
When disposing of an old unit break off any old locks or latches and remove the doors as a safeguard.
LFC50S_W10_IB_final110309.indd 14
09/03/2011 6:08 PM
