GB
4
Getting to know your New Larder
Before use
Please read these instructions carefully before using your new Logik appliance.
The appliance is for indoor and domestic use only.
INTERNAL LIGHT AND THERMOSTAT CONTROL DIAL
Installation
Location
When selecting a position for your Appliance you should make sure the floor is flat and firm, and the room is well
ventilated with an average room temperature of between 16ºC and 32ºC. Locate the appliance away from direct
sunlight and source of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance
not to perform properly. This unit is not designed for use in a garage or any other outside installation. Avoid
locating the appliance in moist areas. It must therefore be installed so that the Appliance has at least 10cm (2.5”) if
free space and the sides have 2cm (3/4”). The Appliance doow can either open to the right or the left, depending
on whichever suits you. See page 4 if you want to reverse the door swing. Do not drape your Appliance with any
covering.
Moving the appliance
Position your appliance in front of its final operating position and gentle slide the appliance into position.
A minimum of two persons must be used to move the appliance.
Leveling the Larder
Remove the packaging support form the base of the appliance and replace with the
2 leveling feet. Make sure the appliance is level. Use the leveling feet at the front.
If the appliance is not level, the doors and magnetic seal alignments will be affected.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate soda. Then rinse with warm water using a
damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry completely before replacing in
the larder. The external parts of the larder can be cleaned with wax polish. If you require more information refer to
cleaning on page 6.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the appliance. If not, please consult a
qualified technician for assistance.
Before switching on!
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE LARDER.
The coolant fluid needs time to settle.
ADJUSTABLE SHELF
GLASS SHELF
SALAD BIN
LEVELLING FEET
BOTTLE STORAGE
LLTL2488GS_GSE_GW_GWE_IB_100524.indd 4
5/24/10 2:14 PM
