English
3
Charging the Headset
Set up the camera following the instructions in the previous section. The computer does not need
to be turned on in order to charge the headset.
Note
A full battery charge for
the headset may take up to
four hours.
1.
The LED on the headset should be
off indicating that the headset
is turned off. If the LED is blinking,
press the Multi-function button
for three seconds to turn
the headset off.
2.
Place the headset in the camera
cradle to charge it.
3.
The Battery Charging LED on
the camera will turn amber while
the headset is charging. This LED
turns green when the headset is fully
charged. If the LED is not lit,
make sure the camera AC adapter
is plugged into an AC outlet.
Also make sure the headset
is making proper contact
with the camera cradle.
Try repositioning the headset in the camera cradle until the Battery Charging LED turns on.
3
3
1
3
Battery charging LED
Multi-function
button
2
623631-0403_Elkhorn-US.book Page 3 Tuesday, September 7, 2004 5:19 PM
