6
English
Using the Camera and Headset
With the camera correctly set and positioned, the headset in place, and your computer on, you are
ready to use your video calling application.
Using the Camera with a Video Calling Application: Turning the Camera/Headset On/Off
To Start.
If you like to use the Start button to launch a particular video call application, use the camera
control settings under the
Other
tab to point to your application. Otherwise, you can launch the
desired application from the Start menu. Once your camera is configured to launch your preferred
default application, press the Start button on the camera to launch the software.
When initiating a call, make sure the headset is turned on by pressing the Multi-function button for
three seconds. You can leave your headset on even after the call.
To Talk.
Press and release (do not hold) the Multi-function button on the headset. To stop talking,
press and release the Multi-function button.
To End.
You can end your video call using your video call software. Press and release the headset Multi-
function button once.
Adjusting Headset Volume
To adjust the headset volume, push the “+” button
to increase volume or the “-” button to lower it.
A tone will sound indicating a change in volume.
When the headset is turned off, the current volume
level is saved.
Muting Headset Audio
You can mute the headset by pressing either the “+”
or “-” button for four seconds. To restore headset
audio, press either the “+” or the “-” button. When the
headset is muted, there will be an audible tone every
two seconds. It is recommended to use the camera
Pause button on your video call software to mute
the audio instead of the headset as the mute status will then be graphically displayed by the software.
7
7
Decrease volume
Increase volume
Headset
623631-0403_Elkhorn-US.book Page 6 Tuesday, September 7, 2004 5:19 PM
