11
12
13
14
9
10
6
7
8
5
13
14
15
16
17
18
19
20
21
22
23
13
Reach into the stand from beneath the display and secure the display
to the stand with 2 thumbscrew caps.
14
Remove the cables from bag 3 and connect them from the display
to the video system and electronics box, indicated by cables 5-8 on the
wiring diagram.
Note: The display requires only 4 cables, even though it features 5 ports.
15
Use the camera screw to secure the camera to the top of the camera
shelf.
16
Use 2 thumbscrew caps to secure the camera shelf to the back of the
display.
17
Verify that the camera is secured to the shelf and that the shelf is
secured to the stand.
18
Connect one end of the camera’s DC power cable and HD cable
(from cable bag 4) to the back of the camera, and thread the other ends
through the slot at the top of the stand.
19
Connect the free ends of the camera’s DC power cable and HD
cable to the electronics box and video system, respectively, indicated
by cables 9-10 on the wiring diagram.
20
Remove the cables from bag 5 and connect them from the video
system to the appropriate component, indicated by cables 11-14 on
the wiring diagram.
21
Connect one end of the network cable (from bag 6) and system AC
power cable to the wall and the other end to the back of the electronics
box, which is exposed through the hole in the lower back of the stand.
Refer to cables 15-16 on the wiring diagram.
22
Turn on power and wait for the system to initialize. The first time, an
Initial Configuration screen prompts you to configure the system. Refer
to the LifeSize Video Communications Systems User and Administrator
Guide for instructions.
23
Tuck loose cables inside the stand, insert the upper lip of the cover
under the display, and press the cover toward the stand until it snaps into
place.
