Cleaning kit LogoClean Plastic
Contents and Operating instructions
Cleaning spatula
Status: 2020-03-319-09
5
3
Cleaning spatula
Description:
Cleaning spatula, 100 mm
10016566
Contents:
3x Cleaning spatulas
Use:
For cleaning the print head of the print engine. - Helps to remove label residue or heavy soiling
from the print head.
For large print engines (print heads) use 2 cleaning spatulas side by side.
Handling:
•
Moisten the cleaning spatulas with LogoClean.
•
Lift the print head and place the spatula in the print engine with the felt side facing up-
wards as shown in the figure (the design of the print engine differs depending on the type
of system, but the application is basically always the same).
•
Close the print engine (print head) so that the spatula is clamped.
•
Allow a few minutes for the cleaning fluid to work.
•
Lift the print head and remove the spatula.
•
Clean with a cleaning stick as described under point 5, repeating the process if necessary.
Cleaning can also be carried out in the installed condition in exceptional cases.
Switch off the system and remove the label material when doing this.