29
PK1500
STACK CUTTER
The basic procedure when using the Stack Cutter is
to mark out the intended cut by drawing lines on
the sides of the timber stack. Draw a vertical line
on both sides of the end of the stack that is to be
trimmed. Waste pieces must not be shorter than 10
mm or longer than 500 mm.
1. Position the cutter by the drawn line.
2. Using the wheel crank, adjust the Stack Cutter to
approximately the correct angle.
3. Align the upper sight exactly with the line. On
the side that is not going to be cut off, drive a screw
into the stack through the hole in the sight.
4. Use the wheel crank to fine adjust the lower sight.
5. Go around the machine and align the cut on the
opposite side.
The sighting rod must be on the side of the stack
that is not going to be cut off.
The sighting rod holder must be fitted in such a
way that you can measure close to the centre of the
stack.
6. Push the sighting rod close to the stack.
7. Make sure that the plastic sight pegs are close to
horizontal position.
8. Tighten the sighting rod in its holder.
9. Align the Stack Cutter and lock the position by
pushing down the locking foot next to the wheel
(and, if necessary, screwing the sighting rod into the
stack – in which case, disregard point 10).
10. Loosen the sighting rod, pull it back so that the
plastic pegs do not get in the way of the saw chain,
and turn it 90 degrees.
Risk that cut pieces of wood are being thrown
out in the operator’s direction.
Stand behind the protective screen. Wear safety
goggles. Ensure that all other people observe the
safety distance.
12. Cut along the line as per the instructions in
“Stack cutting”. Observe all the warnings.
When making the first cut, calibrate the machine’s
plastic sight pegs by pushing them out a few
millimetres and then sawing them off. This will show
the exact path of the guide bar.
MARKING UP FOR END TRIMMING
Summary of Contents for 0458-395-0603
