5
symboler
Nedanstående symboler används i denna bruksanvis-
ning.
Ögonskydd skall användas.
Skyddshandskar skall användas.
Läs noga igenom denna bruksanvisning och
se till att du har förstått innehållet innan du
använder bandslipen.
Iakttag försiktighet.
VarnIngsmärken
Nedanstående dekal med symboler finns på band-
slipen.
Polvändning av bandslipen när den anslutet
till 12 volts batteri.
symbolförklaring / key to symbols
symbols
The symbols below are used in this operator’s ma-
nual.
Eye protection should be used.
Protective gloves should be worn.
Read this manual carefully and make sure you
understand it before attempting to use the
bandsaw blade grinder.
Exercise caution.
WarnIng sIgns
The decal with the symbols below is found on the
bandsaw blade grinder.
Polarity reversal of the bandsaw blade grin-
der when connected to a 12-volt battery.
säkerhetsföreskrifter / safety regulations
slIpapparaT
Följande säkerhetsföreskrifter gäller för slipapparaten:
• Förvara inte bensin i närheten av slipapparaten.
Gnistor från slipskivan eller elanslutningen kan
antända.
• Sågbandet är vasst och skärande. Varning för
personskada. Vid all hantering av sågbandet
använd skyddshandskar!
• Slipskivan får ej vara igång under inställning av
slipapparaten.
• Om slipskivan roterar åt fel håll kan den lossna
och orsaka personskada.
• Kontrollera att slipskivan ej har några sprickor
samt att den sitter fast på axeln. Stoppa genast
slipskivan om onormala vibrationer uppstår.
• Använd skyddsglasögon under slipningen!
slIpapparaT
The following safety regulations apply to the grinder:
• Do not store petrol in the vicinity of the grinder.
Sparks from the grinding disc or the electrical
connection can ignite.
• The bandsaw blade is sharp and can cause cuts.
Warning for personal injury. Wear protective
gloves whenever you handle the bandsaw blade!
• The grinding disc must not be running when
adjusting the grinder.
• The grinding disc can come loose and cause per-
sonal injury if it rotates in the wrong direction.
• Check that the grinding disc shows no signs of
cracking and that it is secured to the spindle.
Stop the grinding disc immediately if abnormal
vibrations occur.
• Wear protective glasses while grinding!