17
LOGOSOL CH3
PLANER
TOP CUTTER
After adjusting or replacing planer knives:
Check that no knives have been left in the machine.
Check that all screws/bolts are securely tightened.
Check that the cutters can revolve freely before
closing the safety hatch.
Adjust the knife knives
so that they reach the
same level and have a one millimetre protrusion.
This is most easily done using Logosol's aluminium
adjustment block.
Slightly loosen the wedge locking screws, and slide
the adjustment block over the knife. Adjust the knife
up or down with the adjusting screws until the knife
touches the block when it is moved over the knife.
(The planer knives protrusion can also be adjusted
with Logosol's magnetic setting for the top cutter.
Securely tighten the planing knives' wedge
locking screws when the adjustment is complete.
Unscrew the adjustment screws at the bottom.
When the cutter's bearing housing has been
adjusted, or when planer knives degree of
removal has changed, the position of the rotating
scale must be calibrated. The indicator on the
height scale on the front of the machine may
also need to be adjusted.
Planer knife adjusting screws
