13
FUNCTIONS
FEED
PERFORM FUNCTIONS
The feed function is used for moving the sawhead back
and forth over the rails. This function is acativated with
the Feed key, and is then controlled by the control lever.
Remember that the enabling switch button has to be kept
pressed down to enable the movement.
To rev up the engine and start the blade,
you have to be in the Feed mode and then
press down the Start key. Stop the engine by
releasing the control lever to its 0 position.
REVVING UP THE ENGINE
FUNCTIONS
To be able to run the different functions in Smart Set, you follow the steps as shown in
the illustration below. Select the desired function on the keypad, Keep the enabling
switch button pressed down. Carry out the selected operation with the help of the
control lever. If you release the enabling switch button, the operation cannot be performed.
1
2
3
/
UP DOWN
1
2
3
