8
FUNCTIONS
Step mode is two adjustable modes that enable you to
quickly repeat a preset value of the saw cut.
Absolute measurements means that the display will
show the distance between the bottom of the sawblade
and the top of the log bed.
The feed key is used for running the sawhead back and
forth over the rails.
Activates the engine to enabling sawing operation. The
engine revs up and then runs at working rpm until the
control lever is released.
Up / Down activates the ability to move the sawhead
vertically.
The 0 key creates a zero point for the position of the
sawhead. The value shown on the display will then start
out from this point.
The display can show measurements in inches or
millimetres. To choose measurement unit you press the
key inch/mm.
This key activates the calibration function of the
machine.
Up / Down
Sawhead position /
Start
REV UP ENGINE
STEP MODE
PROGRAM KEYS
SETTINGS
ABS
0
MEASUREMENT
UNIT
CAL / Back
/
UP DOWN
