Chapter 4 Preparing LogTag(s) for use
37
6 readings out-of-range, return to normal
The second alert condition is not met, as the
total out-of-range events equals 6 (7 required.)
The maximum number of consecutive alert
condition readings however is 6, the alert
condition is 5 consecutive readings, so the alert
DOES go off.
Flashing Red Alert Indicator
Please note following special conditions:
1. If you wish an alert to be indicated on the first reading that is recorded out-of-spec,
place a tick in the box next to "Enable the Alert (Red) indicator when" and remove the
ticks in both boxes next to the "After X consecutive alert readings" and "After X alert
readings have occurred".
2. You can not enter a number into the "After X consecutive alert readings" field which is
larger than the number in "After X alert readings have occurred", since the latter alert
condition would always be met first.
3. Similarly, you can not enter a number into the "After X alert readings have occurred"
field which is smaller than the number in "After X consecutive alert readings". The
software will adjust field values as appropriate.
Advanced Alert Settings
Some LogTags support more detailed alert settings than described before. If LogTag
Analyzer encounters one of these loggers, an additional
button is visible in
the bottom left of the configuration screen.
When this button is pressed, the alert configuration screen changes and displays
additional settings:
The red alert indicator can now be configured independently for upper and lower alert
values.
Summary of Contents for Analyzer
Page 1: ...2 0...
Page 23: ...Chapter 3 Quick Start Guide 23 Only flashes if no alert condition is present...
Page 170: ......
