During Recording
UTREL30-WiFi User Guide
55
Marking a reading with an inspection mark
When you press the
REVIEW
/MARK
button while the UTREL30-WiFi is recording, the next
reading taken will be identified in the downloaded data and on the PDF report with an
inspection mark.
If the
Allow stopping with the Stop button
feature is enabled, a mark will also be
registered when you press the
START
/CLEAR/STOP
button, but do not complete the process
of stopping the logger. An inspection mark will also be recorded if you clear an alarm. A
mark will always be recorded for both channels.
The reading will also be reported to LogTag
®
Online with an inspection mark. The
inspection log in LogTag
®
Online will show an AM or PM inspection, depending on the
time of day the inspection took place.
Clearing an Alarm
During configuration with LogTag
®
Analyzer, you can allow users to clear an active
alarm on the display. This is a useful function for an inspector, so repeated alarms can
be recognized easier.
Note: Since each channel tracks alarm conditions independently, alarms must be
cleared separately for each channel. Only the alarm for the channel shown when
you start the procedure will be cleared.
This display screen shows an existing alarm that
occurred yesterday, but has not yet been cleared.
To clear an alarm, press and hold the
START
/CLEAR/STOP
button.
After approx. 2 seconds the cross will be replaced
with the tick . Release the button when the tick
appears. The normal recording display is shown.
The red LED will stop flashing as soon as none of
the channels show an active alarm.
The alarm will
not
be cleared if you release the button before the appears.
