OWNER’S MANUAL
17
Compact Scooter
Hand Controls
All of the drive controls for the scooter are to be found on the Tiller Control Box
(Photo 6.1).
The Preset Speed Knob
Turning this knob to the left, reduces your available maximum speed. Turning
it to the right, increases the available maximum speed.
The Battery Gauge
This gives an approximation of battery charge and is illuminated for clarity.
The gauge is “RED” empty, to “YELLOW” charge required, to “GREEN” charged.
As the scooter moves over differing terrain, the Battery Gauge will dip up and
down, this is normal. For a more accurate indication, stop the scooter and note
the reading. In cold, damp weather the gauge will dip more often as the
capacity and efficiency of all batteries drops in such conditions.
TIP:
If your battery gauge has gone into the “RED” section you can increase your
remaining range by reducing your maximum speed. Remember you MUST
charge your battery overnight as soon as you can to prevent battery damage.
Operating the Lights
The lights are operated by pressing the blue button on the front console
panel. Press the button once to illuminate the lights, press the button again to
switch the lights off. Switch the lights on to make yourself more visible in low
levels of light, day or night.
Please note that the scooter has a safety circuit to prevent it from being driven off
during charging. If your scooter fails to respond to normal control after a charging
period, please check that the battery charger has been completely disconnected
from the scooter.
The off-board charger must be kept dry in temperatures between -25°C and 40°C
and not be subjected to mechanical damage. In all cases, the charger must only be
repaired by an authorized dealer.
WARNING!
You can only use the original charger from our company. Use other brand charger
may shorten your warranty period, and using an unknown charger may cause
damage to your scooter or may cause a fire.
Use extreme caution to manage the battery and charger. Don’t throw the battery
into fire. You should manage the exhausted battery according to the local law.
Don’t put the battery near to any heating device, which may cause the battery to
explode.
Don’t press the battery or stab it, or let it endure any high pressure, which may
cause short circuit or overheating.
NO SMOKING OR NAKED FLAMES WHEN CHARGING BATTERIES. DO NOT TOUCH
BATTERY PACK TERMINALS WITH METAL OBJECTS.
ONLY USE APPROVED REPLACEMENT BATTERIES. IF DAMAGE TO BATTERIES OR
BATTERY BOXES IS EVIDENT, CONTACT YOUR LOCAL DEALER IMMEDIATELY - DO
NOT ATTEMPT TO SERVICE THE BATTERIES.
DEALER WARNING!
REMOVE METALLIC JEWELLERY WHEN WORKING WITH BATTERIES.
WEAR GLOVES AND GOGGLES IF MOVING LEAKING BATTERIES. REPLACE DAMAGED
OR LEAKING BATTERIES IMMEDIATELY.
Fuses
There is a reset button as described previously. If a fault occurs, the button will pop
out. Switch the scooter off, press the button in and switch the scooter back on.
There is a 30A fuse fitted to the positive terminal of battery. These fuses must be
replaced by an authorized service agent.
There is also a 2.5A fuse fitted in the charger and a fuse in the mains plug of the
battery charger. These fuses must be replaced by an authorized service agent.
ver 2019.05.30E
