Maintenance
This chapter describes the maintenance procedures for the IQ
3
Metal Detector.
Your warranty may be invalidated if you do not follow the maintenance schedule set out
within this user guide. This warranty statement is in addition to the terms of sale.
The following sections provide more information:
■
A list of applicable
safety warnings
to be observed when maintaining the metal detector head
is provided.
■
This section provides guidance for cleaning the metal detector.
■
Air Regulator Unit Maintenance
This section provides some guidance covering maintaining the compressed air regulator.
■
This section provides some guidance covering maintaining the conveyor belt.
■
This section provides some guidance covering adjustment of the reject devices.
■
This section provides some guidance for upgrading the metal detector software.
Maintenance Warnings
The following safety warnings apply when carrying out maintenance operations on an IQ
3
Metal
Detector:
1. LETHAL HAZARD – ELECTRICAL SUPPLIES
2. LETHAL HAZARD – COMPRESSED AIR SUPPLIES
3. NON-IONIZING RADIATION
4. WORKING ON EQUIPMENT
5. REJECT DEVICES
For details see the
Cleaning
Cleaning regime
A typical cleaning regime consists of the 5 stages.
■
Pre-rinse
■
Detergent rinse
■
Rinse
■
Disinfectant rinse
■
Final rinse
125
Summary of Contents for IQ3
