❍
❍
❍
❍
❍
❍
❍
CALIBRATE
CHANGE
RESULTS
RUN DETECT
CALIBRATE
SYSTEM FAULT
RUN ERROR
▼
▲
I S C
L o m a S u p e r s c a n M i c r o
❍
SETUP
ENTER
CANCEL
2
MENUS A to Z
Description:
This facility can be used to synchronise the start of the batch to a particular time of day. For example,
if hourly batch statistics are required starting from 6.30pm, then the Batch Length would be set to
1.00 hour and the Batch Start to 18.30 hours. This would mean that the batch statistics would be reset
and transmitted down the serial link every hour at half past the hour.
Press the [ENTER] key, and then the [
▲
] or [
▼
] keys to adjust the batch start time.
To turn the start time facility off, so that batch statistics are reset and transmitted at multiples of batch
lengths after the batch starts, set the start time to 00.00.
Scope:
00.00 to 24.00. 00.00 will disable this facility.
Default:
00.00
Note:
This menu entry will only appear when Batch Reports are enabled, and the batch units are in terms of
time.
*BTCH START 1.30
●
●
BATCH START
