STORAGE
-
22
-
9. STORAGE
1. Remove priming water filler cap, wash the inside of pump and screw cap again.
If the engine is running, allow it cool for at least half an hour before cleaning. Wipe the
surface of water pump.
2. Engine stop after running for 3 minutes in low speed.
3. Drain the oil while the engine is still warm to assure rapid and complete drain. Add
new engine oil.
4. Gently pull up the starter grip until a resistance is felt, let inlet and exhaust valves in
the “closed” state in case of mist into the cylinder. Return the starter grip gently.
5. Clean the dist and oil stain, put the water pump in a clean and dry area.
6. Clean all exterior surface, touch up any damaged paint and coat other areas that
may rust with a light film of oil.
7. Cover the pump to keep out dust.
●
Using pressure washing equipment can force water into the air
cleaner or muffler opening, and water passing through them can
enter the cylinder, causing damage.
●
Let the engine cool before cleaning water pump. Because water
vapor spilling on the hot engine will result in burns or fire hazards.
Summary of Contents for LC50ZB60-4.9C
Page 1: ......
Page 22: ...CHARACTERISTIC CURVE OF DIESEL ENGINE 20 7 CHARACTERISTIC CURVE OF DIESEL ENGINE...
Page 29: ......
