PROMTS 200i
10
27.
Manual Gas Check:
Press and hold down.
Wire Speed Test:
Press and hold up.
28.
Post Flow Knob
29.
Pre Flow knob
MIG Operation:
1
. Shielding Gas Choice
1)When the wire material is Fe, the shielding gas should be 75% Ar + 25% CO2
2)When the wire material is Ss, the shielding gas should be 75% Ar + 25% CO2
3)When the wire material is Al, the shielding gas should be 100% Ar
2) spool gun switch off(down) on (up)
3) Manual wire switch & air check, Burn back adjust, Slow feed adjust, Post flow adust, Pre flow
knob adjust.
