T: 07752 929 363 E:
sales@longridge.co.uk
W:
www.longridge.co.uk
•
Insert the mount, colour-side down, under the Guide Rail (on top of the
SprintMat
) but this time slide it right across to the back of the parallel
bar.
•
Mark out the borders as before.
5.
Insert the mount back under the Guide Rail, to the parallel bar and up
to the mount stop.
For larger mounts remove the Mount Stop and slide the mount blank up to the
squaring pin instead.
6.
Line up the pencil line with the Guide Rail.
7.
Place the bevel cutter onto the Guide Rail and insert the two Cutter
Stops.
8.
Before cutting: line up the centre of the V on the bevel cutter with the
finish line, draw one cutter stop to the cutter and lock it in position; slide
the cutter back and line up the centre of the V with the start line, draw
the second stop to the cutter and lock it in position.
