2. Installation
This section describes how to install the adapter. For
connecting to the network, you must have the following:
1.
Network adapter card installed to your computer.
2.
Cabling (compatible with network topology)
3
. Connect the Wake-On-LAN cable to the motherboard
(If the WOL function is supported on the adapter)
4.
Software for the adapter card contains both configuration
utilities and drivers
2.1 Unpack and Inspect
Caution:
Under ordinary circumstances, this adapter card will
not be affected by static charge as may be received
through your body during handling of the unit .In
special circumstances where you may carry an
extraordinarily high static charge, it had better reduce
the charge by touching a ground before handling the
adapter card.
Open the shipping gift box and carefully remove all items. In
addition to this User’s Manual, please check the following
items:
y
One 10/100 Fast Ethernet PCI Adapter Card
y
One WOL cable (If adapter supports WOL function)
y
One 3.5” Drivers and Utilities diskette
y
This user’s Manual
Note:
If any of the listed items are missing, please contact
your distributor or reseller
E-4
Summary of Contents for LCS-8038TXR7
Page 1: ...10 100 Fast Ethernet PCI Adapter English Deutsch Italienisch Franz sisch Spanisch Ver 4 6 E 1...
Page 13: ...10 100 Fast Ethernet PCI Adapter English Deutsch Italienisch Franz sisch Spanisch Ver 4 6 D 1...
Page 25: ...Scheda Fast Ethernet 10 100 PCI English Deutsch Italienisch Franz sisch Spanisch Ver 4 6 I 1...
