page 10
1. Push the lever up 2. Fasten the lever 3. Turn the additional locking clamp to secure the lever
Charging using the mains adapter
Only charge the battery via the rear charging socket, using the enclosed charger, connected to
a suitable mains socket (220-240V~).
Before plugging in the charger, make sure that the e-scooter is switched off and that it cannot
roll away.
Take all usual precautions required when dealing with electricity.
Never touch, short circuit or submerge electronic parts, and never spray water underneath the rear
wheel casing.
Always charge the battery under supervision and do not leave the charger plugged in any longer than
necessary once the battery is fully charged.
Begin by plugging the mini-plug of the charger into the socket on the CARVY.
Then plug the mains plug of the charger into the power socket. The charging LED lights up on the
mains adapter while the charging is in progress.
Once the CARVY has finished charging (the charging LED lights up green), pull out the mains plug,
remove the mini-plug from the CARVER. Always make sure that the mini-plug is pulled out before
riding off, to avoid any damage.
Store and use the mains adapter inside, in a dry place and at room temperature.
