Operation Manual
18
2.
Come down from the machine.
1.5.12.4 In case of lightning, do not leave the cab or be sure to stand away from the machine.
1.5.13
Start of engine
1.5.13.1 If a warning label is attached on the start switch or control device, do not start the engine or
pull the control device.
1.5.13.2 Before the start of engine, move all the hydraulic control levers to neutral position.
1.5.13.3 Engage the transmission operating device into the neutral position.
1.5.13.4 Apply the parking brake.
1.5.13.5 The exhaust of diesel engine contains the harmful combustion products. Operate the engine
in a well-ventilated place, and exhaust the gas to the outdoor in case of the closed place.
1.5.14
Safety of getting on and off the machine
1.5.14.1 Get on and off the machine only along the ladder and/or handrail. Before boarding the
machine, sweep and check the ladder and handrail. Perform all the necessary repairs.
1.5.14.2 When getting on or off the machine, face the machine and keep three-point contact with the
ladder and handrail. Note: Three-point contact may be both feet and one hand or one foot and both
hands.
1.5.14.3 Do not board or come down from a moving machine and never jump down from the machine.
Do not get on or off the machine carrying the tools or items. Pull the equipment onto the platform with
the drawstring. Do not take the control lever as the handrail when getting in and out of the cab.
1.5.15
Preparations for the operation
1.5.15.1 Make sure that no one is around the machine.
1.5.15.2 Clear all obstructions along the driving route of machine. Beware of the obstructions which
may easily lead to the danger, such as the wires, ditches, etc.
1.5.15.3 Make sure that all windows are cleaned and doors/windows are fixed at the open or closed
position.
1.5.15.4 Adjust the rear-view mirror to get the best line of sight around the machine.
1.5.15.5 Make sure that the horn, reverse alarm (if equipped) and all other alarm devices are working
properly.
1.5.16
Operation
1.5.16.1 Only when you sit in the driver's seat and wear the seat belt, you can operate the machine.
Only when the engine is running, you can operate the control lever.
1.5.16.2 Operate the machine and working tools on open ground, and check if all the controllers and
protection facilities are acting correctly.
1.5.16.3 Before switching on the machine, ensure that no one is in the dangerous zone.