CDM816D WHEEL LOADER
33
6.
During the driving, the forward gear shifting can be made without stopping the vehicle and
stepping down the brake pedal. When shifting from low speed to high speed, the throttle pedal shall be
firstly released and the gear lever shall be operated at the same time, and then the throttle pedal shall
be stepped down; and on the other hand, slow down first to make the rotation speed of transmission
output shaft approach that of the transmission shaft before gear shifting.
7.
The direction change (from forward to backward or backward to forward) can only be carried out
after stopping.
8.
To apply the brake during driving, there is no need to firstly set the gear lever in the neutral, and
the brake pedal can be directly stepped down.
9.
The full-load running can be made only when the water temperature of the diesel engine is higher
than 55
℃
and the oil temperature is above 45
℃
. During the operation, the water and oil temperatures
of the engine shall not exceed 95
℃
, and the oil temperature of torque converter shall not be higher
than 110
℃
.If the water or oil temperatureexceeds the allowable value due to the heavy-duty operation,
stop the vehicle and allow such fluid to cool.
10. After operating the boom or tilt control lever to make an action, the control valve stem shall be put
in the neutral.
11. It is not allowed to lift the bucket to the highest position to carry the materials, and the lower hinge
point of boom shall be about 300 mm above the ground during the transport, to ensure the stable
driving.
12. The power of the diesel engine for this loader decreases with the increase of altitude, ambient
temperature and relative temperature; consequently, users are required to correct the actual power of
loader in combination with the local environment according to the requirements for power correction
stated in ZH4100 or the provided diesel engine operation and maintenance instruction, to correctly use
the loader.
(ii) Main technical data for normal operation
1.
Engine
A. Temperature of the circulating coolant (°C)
Appropriate temperature of water inlet:
45-60
Appropriate temperature of water outlet:
60-90
Max. temperature of water outlet:
95
B. Engine oil temperature (
℃
)
Min. temperature in the oil pan:
45
Appropriate temperature in the oil pan:
80
Max. temperature in the oil pan:
95
C. Reading of the engine oil pressure gauge (Mpa)
For idle speed:
0.15-0.18
