116
3
0.2
48
±5
0.5
48
±5
4
0.3
65
±5
0.75
65
±5
5
0.4
82
±5
1.0
82
±5
6
0.5
99
±5
1.25
99
±5
7
0.6
116
±5
1.5
116
±5
8
0.7
134
±5
1.75
134
±5
9
0.8
151
±5
2.0
151
±5
10
0.9
168
±5
2.25
168
±5
11
1.0
184
±5
2.5
184
±5
General Parameters of Fuel Sensor
Oil Level
Empty oil
level
1 / 8 oil
level
1/4Oil
Level
1/2 Oil
Level
3/4 Oil
Level
7/8 Oil
Level
Full oil level
Resistance
10±5
33±5
58±5
95±5
132±5
157±5
180±10
3) If the sensor is fault-free, then inspect the cable from each sensor to the front of the
instrument, to inspect whether it is normal without damage or not.
4) If there is no damage, then loose, short circuit and, connect a small resistor in series, then the
indicator will display the max. value, the indicating hand does not point to a mark, if it cannot
normally indicate, and then replace the meter.
5.7.3 SOLDERING
When perform soldering on the whole machine,
follow the following regulations to avoid damage
to machinery and security incidents.
1. Before soldering, shut down the engine,
unplug the key switch, turn off the negative
pole switch of battery;
2. Before soldering, must remove the wiring
harness connectors of the dashboard to avoid
damage to instrument;
3. While welding, must keep away from the wire
bund of the machine and take measures to
avoid flash and the damage caused by flying
sparks;
4. Continuously use the voltage more than
200V;
5. Keep the length of the cable between
