44
1.8.9 FRAME MAINTENANCE WITH THE WORKING DEVICE SUPPORTED
UP
When the frames are maintained with the working device lifted, it is necessary to lock up
the front and rear frames with the frame fixing rods. Set the joystick to the “neutral”
position, lock up joystick with locking equipment, and then support the working device with
supporting rods.
Before lifting, wedge the wheel from the opposite
side. Lift the lift arm and place a support rod
below the lift arm.
1.8.10 MAINTENANCE ON THE TOP OF THE MACHINE
When conducting maintenance on the top of the machine, make sure your standing point
is clean and no barrier, as well as comply with the following items for the prevention of
falling:
Spilled lubricant or grease is not allowable.
No tools or spare parts displayed around.
Pay attention to your walking steps
Prohibit jumping from the machine. Be sure to
use ladder and handrail when up and down the
machine, and always maintain a three-point
contact (two-foot one-hand or two-hand one foot).
If necessary, use protective equipment.
The tops of the hood and tire are smooth and
dangerous; standing on them is prohibited..
