80
Turn the electric lock key anticlockwise to the off position so as to shut down the
engine and cut off the control circuit, and then pull out the key.
Set each switch at middle position or off position.
Close the left and right doors, and then go down the stairs in accordance with the
relevant provisions.
If the loader is to be parked for long time (for example, all the night), just open the
side door of the hood and pull the negative pole switch of battery to the off position,
so as to turn off the power supply.
If no anti-freezing fluid is added in the coolant before the loader leaves the factory,
just open all water drain valves of the engine after parking the loader in winter,
discharge all coolant from the cooling system and the evaporator in A/C system, so
as to prevent any part from being frozen and damaged. If the anti-freezing fluid is
added when the loader leaves the factory, please operate as indicated in the
anti-freezing fluid nameplate.
Lock up all equipment, pull out the key and take it with you.
NOTE: Be sure to park the loader on a flat ground. If it is necessary to park the
loader on a slope, be sure to block up the wheels with chocks, so as to prevent the
loader from moving.
If the loader is to be stored for long time, please operate in accordance with the
following requirements:
1. Before Storage
1) Clean up each part of the loader, dry the loader up and then store it in a dry
warehouse. If the loader can only be stored outdoors, be sure to park it on a concrete
ground where water may drain easily, and cover it with canvas.
2) Before storing the loader, fill the fuel tank with fuel, apply grease to each moving pin,
moving shaft and propeller shaft, and replace the hydraulic oil.
3) Pull the gear shifting joystick to the neutral position.
4) Pull up the parking brake handle so as to apply the parking brake.
5) Place the bucket on the ground horizontally and push the working device joystick to
the middle position.
6) Set each switch at the middle position or off position, and then lock up all doors.
7) Apply a thin layer of grease onto the exposed portion of the hydraulic oil cylinder
piston rod.
8) Detach the battery from the loader and place it separately.
9) If the atmospheric temperature may reduce below 0
℃
, please add anti-freezing fluid
into the engine coolant, and make the anti-freezing fluid reach the engine and the
evaporator of A/C system. Alternatively, discharge all water in the cooling system, and
