93
2. Inspect the level of electrolyte every day. Maintain the electrolyte at an appropriate
level, so as to prevent the battery from getting damaged. At high temperature, please
use weaker electrolyte. Dilute the electrolyte of which the specific gravity is 1.280 until
the specific gravity is lowered to 1.200-1.240, and fully charge the battery. Whenever
the specific gravity reduces to 1.160, be sure to re-charge the battery. If being placed
at high temperature for long time, the battery may automatically discharge its
electricity at a relatively high rate. If the loader will be parked for several days, please
detach the battery and place it in a cool place.
NOTE: Don’t place acid battery near a lot of tires, for the acidic gas may harm
rubber.
3. Maintain and repair the fuel system in accordance with the Section “Engine Fuel
System” in this Manual. Before filling the fuel, inspect the level of fuel in the fuel tank.
Both high and low temperature can cause the concentration of materials in the fuel
tank.
4. Carry out lubrication in accordance with the “Regular Repair Chart” or the lubrication
tag on the machine.
5. Don’t park the loader under sunshine for long time. Park the loader under the covering
material, so as to prevent sunshine, dirt and dust.
①
If no appropriate covering material is available, please cover the loader with
canvas. Be sure to prevent dust from entering into engine, gearbox or hydraulic
system.
②
Under the high temperature and high humidity, all parts of the loader may get
corroded, and they may get corroded easily in rainy days. Rust and pocket may
appear on metal surface, and spots may appear on the surface of other parts.
③
Apply the anti-corrosion lubricating oil onto the unpainted or exposed surfaces.
Use insulating compound to protect wires and terminates. On the damaged
surfaces, use paint or appropriate antirust agent to prevent rust or corrosion.
4.7.3 PERATION IN DUSTY OR SANDY AREA
1. In most areas, the loader may generate dust in the course of work. However, when the
loader is used in a place where there is a lot of dust and sand, protective measures
shall be taken.
2. Keep the cooling system and cooling areas clean, clean them up with compressed air,
and take this measure as frequently as possible.
WARNING: When using the compressed air, please wear the safety goggles
1. When maintaining or repairing the fuel system, be careful so as to prevent dust and
sand from getting into the fuel pipeline.
2. Maintain the air filter from time to time, inspect the air control indicator every day, and
keep the dust cover and dust valve clean. Try best to prevent dust and sand from
