113
Change the oil filter when change the mechanic oil.
5.6.8 REPLACEMENT OF ENGINE OIL FILTER
1. Clean the area near to the install seat of the
filter of the engine.
2. Remove the oil filter with the belt wrench.
3. Clean the contact surface of the seal gasket
of the install seat with a clean cloth. If the
old O-ring is glued to the install seat, replace
it.
4. Install a new O-ring, fill the new oil filter full
with clean oil, and seals the contact surface
with a layer of clean mechanic oil.
5. Install the oil filter to the install seat; tighten it
to the surface of the oil filter gasket with install
seat. Tighten the oil filter according to the
regulated requirement with belt wrench.
6. Inspect oil level; if the oil is insufficient please
add more.
To tighten the oil filter excessive tight may damage the seals and cause leakage
5.7INSPECT ELECTRICAL SYSTEM
The electrical system of the machine is mainly consists of batteries, energy conversion devices
(generator, starter) and power consuming devices (instruments, devices, etc.).
Warning
