39
ROUTING DERAILLEURS (Figs. 1 & 2)
Mechanical Unit : The derailleur casing goes in through the last hole of the handlebar
end cap (31) and comes out through the small hole beside the brake knob (21 & 22).
Depending on the handle model, the derailleur casing must pass either through the
outer groove of the handlebar (Fig. 1) or under the handlebar (Fig. 2).
Electrical unit : The route is the same. Thread the wire into the outer groove of the
handlebar (Fig. 1) and fix it with sticky tape.
ASSEMBLY WITHOUT THE TENSIONERS
If you do not wish to use the tensioners, you can replace them with the casing
supports (33).
These replace the tensioners, while the rest of the routing remains unchanged. Align
a casing end between the casing and the casing support (33).
Fig.3
31,8
74
Lp
Fig.5
Fig. 3
Summary of Contents for AERO DESIGN HANDLEBAR 2
