-9-
!
!
Headless mode
The indicator on the drone will flash once every 4 seconds.
*
When the battery level is normal, the drone can fly to a distance of
500 m at a maximum altitude of 100 m.
*
When the battery level is low, the drone can fly to a distance of 20 m
at a maximum altitude of 20 m.
*
If the rear indicator starts to flash rapidly, this indicates that the GPS
signal is weak and the drone cannot determine its position.
*
GPS mode cannot be used indoors.
1
.
Configuring the forwards direction
When you switch on the drone for the first time, the direction in which the
front side of the drone is pointing will be set as the forwards direction.
2
.
Enabling headless mode
①
After pairing the remote control with the drone, hold down
the right joystick for approximately 3 seconds. The remote
control will beep 8 times to indicate that headless mode is
enabled. To disable headless mode, hold down the right
joystick again for approximately 3 seconds.
②
In headless mode, you do not need to determine the
drone’s orientation. You can move the joysticks on the
remote control to make the drone move in the corresponding
direction.
*
If the rear indicator starts to flash rapidly, this indicates that the optical
signal is weak and the drone cannot determine its position.
*
Performance may be impaired in dark surroundings, areas with
reflective surfaces (e.g. water), or at altitudes of more than 6 m.
*
Optical flow positioning only supports altitudes of less than 6 m.
Flight modes
Optical flow positioning
Front indicator is constant white, rear indicator is constant
yellow.
GPS mode
Front indicator is constant white, rear indicator is constant
green.
