11
RECORDING TO USB DEVICE
SOFTWARE UPGRADE GUIDE
When a USB device is connected it is possible to record directly to it.
• Select the program to be recorded
• Press the REC button to commence recording
• Select YES/NO button as desired
• Press OK to commence
• Recording will commence
• Note if your USB device is not suitable there may be problems with record function and
you may require a device with more capability or Speed
• Refer to RECORD MANAGER to update or delete programs
Software upgrades are an integral part of a successful Freeview program.
• OTA UPGRADE (Freeview Over The Air Service)
From time to time a message will display showing an option to upgrade the software on
your set. It is recommended that you select YES. This will automatically upgrade your
software. It may take a few minutes. Do not switch the power OFF. At the end of the upgrade
the unit will automatically have upgraded the software. The unit will need to be re-tuned to
receive all of the available channels. Follow the previous set up guide under MAIN MENU/
INSTALLATION/AUTO SEARCH to re tune all channels.
• SCHEDULED UPGRADE
The unit can be set to automatically upgrade itself by setting the menu to UPGRADE in
Standby or scheduled mode.
Press MENU button. Use the UP/DOWN/RIGHT/LEFT/OK buttons to navigate to the
SETTING/UPGRADE menu. Press the RIGHT button to enter the OTA upgrade sub menu.
Press UP/DOWN/RIGHT/LEFT/OK buttons to set your desired preferences. Press
RETURN/EXIT to exit menu