Installing the Camera & Optional Extension Cable
4
Ceiling Mounting:
1. Remove the Mounting Bracket from the back of the
Camera (4 screws)
2. Drill a hole in the ceiling large enough to pass the
BNC/Power Cable through.
NOTE
: If using the Ceiling Mounting method, run the
Extension Cable to the location prior to mounting the
Camera.
3. Connect the BNC/Power Cable end of the Camera
to the BNC/Power connections on the Extension cable
before installing the Camera Base.
4. Screw the Camera Base to the ceiling.
5. Angle the Camera by loosening the side screws.
Set the desired angle, and tighten the screws.
6. There are two screw holes on the Dome cover –
align these holes with the screw holes on the base.
Once the holes are aligned, adjust the Dome Insert
so that the opening is aligned with the Lens.
Place the Dome Cover over the Camera and Base,
making sure to align the dome cover holes with the
holes on the camera base.
7a. Screw the two side clip screws on the Dome Cover
into the base to hold the dome cover in place.
7b. Use the Rubber Dome Ring to seal the Dome to
the Base.
1
4
5
6
7a
7b
