Wireless
Receiver
8
Wireless Receiver
1.
DC 9V INPUT
– Connection port for
the 9V Power Adaptor (provided with
this system). Connect the Power
Adaptor to a power source.
NOTE:
It is recommended that the
receiver be connected to a surge bar or
similar to protect the equipment from
damage.
2.
CAMERA CONNECTION DIP
SWITCHES
- Use the DIP Switches
to search for cameras. These
switches are set to default positions
(based on Model Number). Please do
not adjust these switches without first
consulting technical support.
3.
AV OUT
– Connect the provided AV Cable to the Receiver. Connect the Audio and Video ends of the
cable to a TV, VCR or other viewing device.
Control Buttons
1.
AUTO BUTTON
– When the receiver is set to AUTO Mode, it will
continuously switch between the cameras that are set to ON (see
Camera Connection DIP Switches above). The dwell time is set to 4
seconds per camera (by default), however this can be adjusted to 2~30
seconds. To adjust the dwell time, press and hold both the AUTO and
MANUAL buttons at the same time – this will produce beeps indicating
one second increments. Once the desired dwell time has been set,
release the buttons.
2.
MANUAL BUTTON
– Press the MANUAL button to switch between
available cameras. The Receiver will switch to a different camera (if
available and configured) each time that the MANUAL button is pressed.
1
2
3
CAM1 ON
CAM2 OFF
CAM1 OFF
CAM2 ON
CAM1 ON
CAM2 OFF
CAM1 ON
CAM2 ON
UP
DOWN
