www.lorexcctv.com
LW2002AC1 SERIES QSG_EN_R1 Page 2
PORTABLE COLOR LCD DIGITAL WIRELESS
CAMERAS (BLACK OR WHITE)
LW2002AC1 SERIES - QuICK START GuIDE
2. PoWeRInG CAMeRA
The Camera can be powered either by using the pro-
vided Power Adaptor, or using batteries (requires 4 x
AA Batteries, not included).
NOTE:
Wireless cameras require a power source
(either an electrical outlet or battery power) to operate.
If you plan to permanently mount the camera in a loca-
tion, it is recommended to use the included Camera
Power adaptor to prevent interruptions to the video
transmission as batteries are intended as a temporary
power solution only.
1. Remove the Battery compartment cover off the base of the
Camera.
2. Insert 4 x AA Batteries (not included). Make sure to correctly
line up the Positive (+) and Negative (-) terminals of the
batteries.
3. Slide the Battery compartment cover back on.
NOTE:
It is recommended to remove the batteries from the
camera when not in use.
The batteries are intended for short
term, portable Camera use only.
A. UsInG PoWeR ADAPtoR
Connect the Power Adaptor to the Female Barrel Power
termination on the Camera. Make sure the power adaptor
is placed into a grounded outlet or surge bar to protect
the camera from power fluctuations.
B. UsInG BAtteRIes*
It’s all on the Web
For detailed setup information,
please refer to your User’s Manual.
For additional information, please
visit our website
www.lorexcctv.com/support
3. ADDInG tHe ACCessoRY CAMeRA to YoUR sYsteM
The Pairing Function assigns each camera to a different
channel on the wireless receiver (connect up to 4 Cameras),
and is necessary for configuring additional cameras. By
default the camera that came with the LW2002W or LW2002B
system is assigned to channel no. 1.
NOTE:
It is highly recommended to pair the Accessory
Camera to the Receiver before permanently mounting the
camera.
For detailed information, please check the owners
manual for the LW2002 system available at
www.lorexcctv.com.
1. Press the MENU button on the Receiver. Navigate to the
PAIRING Menu option by pressing using the
▲▼◄►
keys to navigate. Press the OK button to open the
Pairing Menu.
2. Select a channel by pressing the UP and DOWN
▲▼
arrows. Press the OK Button on the receiver to accept.
3. Press the PAIR button located on the bottom of the
Receiver using a pen tip or paperclip.
4. A message will be displayed on the Receiver screen.
The Receiver will count down from 30~0 – you must press
the PAIR button on the Camera during this time to
successfully pair the Camera.
NOTE:
If the button on the Camera is not pressed, the
Receiver will return to the view screen, and no pairing will
take place.
5. Press the PAIR button on the back of
the Camera.Once the camera has been
paired, it will be immediately viewable on
the Receiver Monitor.
Set the alarm sensitivity on the camera. Turn the
wheel on the side of the camera all the way down
to decrease sound sensitivity. This means that the
alarm is only triggered by loud noises. Turning
the wheel the other way will result in the opposite.
See the User’s Manual for complete details on the
alarm function.
C. settInG ALARM sensItIVItY
