4
Getting Started
3.
A:
Connect an Ethernet cable (included) to the
NET
port on the camera and connect
the other end to an available LAN port (usually numbered 1~4) on your router (not
included). The blue Network LED on the camera will glow blue when the camera is
connected to your network.
3A
Router
Ethernet Cable
• For instructions on setting your camera up for WiFi, see “WiFi Setup” on page 21.
• OR:
B: OPTIONAL:
If your router supports WPS, press and hold the
WPS
button on your
router until the WPS light turns on. Then, press the
WPS
button on the camera within 1
minute. The camera will automatically connect to your WiFi network and the blue
Network LED on the camera will turn on.
3B
Press and hold the WPS button
on the router
Then, press the WPS button
on the camera
NOTE:
Not all routers support WPS, and the location of the WPS button on your router
depends on your router model. Check your router’s instruction manual for details.
