LORTONE, inc • 12130 Cyrus Way, Mukilteo, WA 98275 • Phone: 425-493-1600
5/10
Page 2
Copyright © 2010 Lortone, Inc
SETTING UP YOUR MACHINE
Check to make sure you have the following parts:
(1)
TS10 Frame with Bearings and Drive Belt
(1)
Blade Guard
(1)
Splash Shield
(1)
Blade (included in TS10-C only)
(1)
Belt Guard
(1)
Vise (included in TS10-C only)
(1)
Belt (included in TS10-C only)
(1)
Hood (included in TS10-C only)
(1)
Operators Manual
(1)
Warranty Card
If any parts are missing, please contact your dealers or the factory immediately.
MOTOR INSTALLATION
Note:
A 1/3 hp, 1725 RPM is recommended for proper operation. Motor pulley should be 2” to 2 1/2” diameter.
Drive belt should be selected to match desired motor mounting position. Pulley and drive belt are included with
the TS10-C only.
Make sure the saw is secured to the base (TS10-C). For TS10 Basic, secure saw and motor to work area.
Place motor pulley on the motor shaft and securely tighten the
set screw on flat of motor shaft.
Install belt and adjust motor to obtain correct belt tension. Do not overtighten the belt as this will lead to
excessive noise and premature bearing wear. The belt should not deflect more than 1”.
BLADE INSTALLATION
Slip the blade into the saw slot at an angle (Fig. 1) and slide it onto the shaft.
Slide the second flange next to the blade and tighten the arbor nut securely (Fig. 2).
Do not over tighten as this can warp the blade.
OPTIONAL VISE INSTALLATION
Attach the vise parallel to the trim table using the two self-tapping screws (Fig. 3).
Clamp a pencil into the vise with the point just touching the front of the blade behind the rim.
Rotate the blade (Fig. 4) rearward so pencil mark shows above the table.
Slide the vise and pencil rearward. Pencil point should touch the blade at the same spot.
If necessary loosen the screws and adjust the guide bar supports.
•
•
•
•
IMPORTANT!!!
Read the following instructions before assembly or use of your machine. Failure to
follow instructions could result in damage to the machine or injury to operator.
•
•
•
Fig. 1
Fig. 2
•
•
•
•
•
Fig. 3
Fig. 4
