©Copyright LOTRONIC 2016
8ROLL-FX
Page 4
CONTROL PANEL
To access the main menu press the MENU button. Press the UP or DOWN
buttons until you reach function you wish to change. When you reach the
function you wish to change, press the ENTER button. When a function is
selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button, and then press and
hold the MENU button for at least three seconds to confirm and lock the
change into the system memory. To exit without making any adjustments, press the MENU BUTTON. The display will
lock after 30 secondes. Press the MENU button for 3 seconds to unlock.
FUNCTION MENU
ADDR
A001 -A 512, DMX Address setting
CHND
10 ch
21 ch, select the channel mode
SLND
MASTER / SLAVE OPTION
SHND
Sound active/auto mode (Speed SP0-SP9)
SOUD
On – Off (SOUND CONTROL)
SENS
000 – 100 Sound sensitivity control (0 close, 100 The most sensitive)
BLND
Yes/no (stand-by mode)
LED
On - Off (Background LIGHT ON/OFF)
DISP
Disp
Dsip (Reverse Display)
PAN
(YES/NO (pan inversion)
1TIL
Yes - No (TILT1 Reverse)
2TIL
Yes - No (TILT2 Reverse)
MANU
PAN, TILT1, TILT2, RED1, GREEN1, BLUE1, WHITE1, RED2, GREEN2, BLUE2,
WHITE2, DIMMER, STROBE, manual Test
HOUR
0—9999 (Use Time)
TEST
Test
RSET
Reset
Settings
DMX Address Setting
1. Press the MENU, UP or DOWN button until “
ADDR
” is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. Press ENTER to confirm.
3. Connect your DMX Controller
DMX channel mode
1. Press the MENU button until “
CHND
” is displayed, press ENTER. Either “
10CH
”, “
21CH
” will be displayed
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to confirm and exit.
SLND – Slave mode in a Master/Slave configuration
Press the MENU button until
Slnd
is displayed. Press ENTER. Use the DOWN/UP button to select
Mast
(MASTER) or
SLAV
. Once the mode has been selected, press the ENTER button to confirm.
SHND – SP0-SP9: Sound or Auto optional (Speed 0-9)
1. Press the MENU button until “
SHND
” is displayed, press ENTER and choose AUTO.
