©Copyright LOTRONIC 2016
8ROLL-FX
Page 5
2.
“Sh X”
will now be displayed, “X” representing a number between 0-9. Press the UP or DOWN buttons to select
the desired speed and press ENTER.
SOUD - Sound Active mode
1. Press the MENU button until “
SOUD
” is displayed, press ENTER.
2. The display will show either “
ON”
or
“OFF
”. Press the UP or DOWN buttons to select “
ON
” to activate sound active
mode, or “
OFF
” to deactivate sound active mode.
3. Press ENTER, then press and hold the MENU button for at least 3 seconds to activate.
SENS - Sound sensitivity
1. Press the MENU button until “
SENS
” is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound sensitivity, 0 being
the least sensitive and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
BLND - Stand by mode.
1. Press the MENU button until “
BLND
” is displayed and press ENTER. Either Yes or No will be displayed.
2. To activate Standby mode, select “
Yes
” and press Enter to confirm. To deactivate Standby mode, select “
No
” and
press Enter.
LED - Display back light
1. Press the MENU button until “
LED
” is displayed, press ENTER.
2. The display will show either “
ON”
or
“OFF
”. Press the UP or DOWN buttons to select “
ON
” to keep the LED display
on at all times, or “
OFF
” to switch to have the LED display switch off after 10 seconds.
3. Press ENTER to confirm. To switch the display on again, press any button.
Display Reverse 180°
1. Press the MENU button until “
DISP
” is displayed, press ENTER.
2. Press the UP button to select “
DSIP
” to reverse the display, or “
DISP
” to change the display back.
3. Press ENTER to confirm.
PAN - Pan Inversion
1. Press the MENU button until “
PAN
” is displayed, press ENTER. Either Yes or No will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm. To
deactivate Pan inversion, select NO and press Enter.
1TIL/2TIL - Tilt Inversion
1. Press the MENU button until “
1/2TIL
” is displayed, press ENTER. Either
“YES”
or
“NO”
will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm. To
deactivate Tilt inversion, select NO and press Enter.
MANU -
In this mode to select PAN, TILT1, TILT2, RED1. GREEN1, BLUE1, WHITE1, RED2, GREEN2, BLUE2, WHITE2,
DIMMER, STROBE, Manual Test
HOUR - With this function you can display the running time of the unit.
1. Press the MENU button until “
HOUR
” is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
VER - With this function you can display the software version of the unit.
