Note
This step is necessary only if when completing step 7 of the
master server pre-installation tasks, you set KeyFileName in the notes.ini
file to a server (or other) ID rather than a valid administrator ID.
3.
Go to a Notes client to perform the setup procedure.
For details, see “Setup procedure for all platforms.”
For some general administrative tasks, such as backup and recovery, you
need to use the same iSeries commands and interfaces that you use to
administer Domino servers on iSeries. For details and examples, see the
Installing and Managing Domino for iSeries book or the Domino for iSeries
Help database (i400help.nsf).
Installing a Document Manager replica server on iSeries
The instructions in this section assume that you have already completed
these tasks:
•
Set up the required equipment listed in Planning your Lotus Domino
Document Manager installation.
•
Performed the planning recommendations outlined in Planning your
Lotus Domino Document Manager installation.
ZZ
Installed the
master server.
Information and procedures for installing Lotus Domino Document Manager
on an iSeries replica server are organized as follows:
•
Pre-installation tasks
•
Installation procedure
•
Post-installation tasks
Performing replica server pre-installation tasks for iSeries
While the actual installation of Lotus Domino Document Manager is simple
and straightforward, it does require some preplanning on your part. Use the
checklist below to ensure a smooth installation.
Note
If you are upgrading from a previous version of Lotus Domino
Document Manager (Domino.Doc), follow the instructions for Performing
replica server pre-upgrade tasks for iSeries.
1.
Check the Domino for iSeries Web site for the latest tips on installation
and use, and to verify that you have all of the recommended fixes. Go to
http://www.ibm.com/servers/eserver/iseries/domino
and select
Document Manager.
46 Document Manager Installation Guide
