Skill requirements for installing on Windows
To install Lotus Domino Document Manager, the installer should be familiar
with:
•
Server and client startup and shutdown procedures.
•
Domino administrative tasks, such as setting up Domino Directory
(Public Name and Address Book) entries.
•
The server’s TCP/IP settings.
Replica installers should also be familiar with replication of Domino servers,
and whether server-to-server replication has been attempted on the subject
Domino server.
Installing a Document Manager master server on Windows
The instructions in this section assume that you have already completed
these tasks:
•
Set up the required equipment listed in Planning your Document
Manager installation.
•
Performed the planning recommendations outlined in Planning your
Document Manager installation.
Information and procedures for installing a Document Manager master
server on Windows are organized as follows:
•
Pre-installation tasks
•
Installation procedure
•
Post-installation tasks
Performing master server pre-installation tasks for Windows
While the actual installation of Lotus Domino Document Manager is simple
and straightforward, it does require some preplanning on your part. Use the
checklist below to ensure a smooth installation.
Note
If you are upgrading from a previous version of Lotus Domino
Document Manager (Domino.Doc), follow the instructions for Perfoming
master server pre-upgrade tasks for Windows.
1.
Gather and have on hand information that you will need to provide
during setup. See Planning your Document Manager installation.
2.
Verify that you have administrator access to Windows on the server
where you will install Document Manager.
Chapter 5: Installing Document Manager on Windows 65
