47
GB
IE
Type “B11” appliance (see data plate)
1) Natural Discharge (fig.3)
Connection to a chimney with natural draught made reliably efficient by means of an anti-wind fitting and discharging
the products of combustion directly outside.
2) Forced Discharge (Fig.4)
The gas supply to the appliance must be directly interlocked to the system of forced discharge and must cut off
automatically in the event that its capacity goes below the values prescribed by item 4.3 by the UNI-CIG norm 8723.
Supplying the appliance with gas again must only be possible manually.
In the event of installation under a hood, the end part of the discharge pipe of the appliance must be at least 1.8 m from
the surface on which the appliance is placed (ground). The section of the discharge pipe outlet must be placed inside the
perimeter of the hood’s base.
NATURAL DISCHARGE Fig.3
FORCED DISCHARGE Fig.4
1) Anti-wind chimney
1) Extractor hood
2) Interlocking
Type “B11” appliances are supplied upon request with chimney or chimney and anti-wind (blowback) device to be
assembled and delivered separately.
OBSERVATIONS AND ADVICE
Always keep the water level checked.
ATTENTION! Do not start up the appliance without water.
Use the appliance only under surveillance.
CLEANING AND MAINTENANCE
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
The enamelled parts should be washed with soapy water.
Important: As well as ordinary cleaning and maintenance, it is advisable to have the installation checked by an
installer at least once a year.
It is therefore suggested to draw up an after-sales assistance contract.
WHAT TO DO IN THE EVENT OF A BREAKDOWN
Turn off the gas tap and notify the after sales service.
