25
IT
CH
GB
IE
INSTRUCTIONS FOR USE
Attention!
Use the appliance only under surveillance.
- Never start up the appliance without water.
With pasta cookers it is possible to cook pasta, vegetables, rice, eggs, legumes, etc.
WATER SUPPLY CHARACTERISTICS
The system must be connected to a drinking water supply with the following characteristics. Failure to do so
automatically
invalidates the guarantee
Total hardness:
0,5 to 5°F to prevent the build-up of lime-scale
Pressure:
50 to 250 kPa (0,5-2,5 bar).
Chlorine ion concentration (Cl-)
: not more than 10 ppm (acceptable value) to avoid damaging the internal steel
elements
pH
: over 7
Electrical conductivity
: 50 to 2000
µ
S/cm (20°C)
TURNING ON
Check that the water drainage tap is turned off.
1) When powering the device, the red light flashes briefly for about ½ second.
2) In the absence of water in the tank the red light keeps flashing.
3a) Turn on the tap to load the tank to the desired level, which must be higher than the minimum level probe and do not
exceed the maximum level, which is marked on the tank by the symbol (--)
3b) In models with automatic load, the water starts loading and you can select the desired level by pressing the button
with symbol (level button)
4) Switch on the main switch installed above the appliance. Turn the control knob corresponding to the hotplate from
position “0” to the degree of coking desired, between 1 and 4.
The white light shows that the heating element is working
To turn off the appliance, turn the knob into position “O”.
EMPTYING THE TUB
To carry out this operation, it is necessary to open the outlet tap (lever in vertical position) which can only be reached
through the cabinet door situated below the appliance.
ANOMALIES
If the probe does not detect the presence of water in the tank for more than 15 sec. the system disables the heating
element: the alarm is indicated by a flashing red light
When the probe returns to detect the presence of water, the heating element is activated and the red light is turned off
NOTE: the filling phase is monitored by the system through the TIME-OUT.
PASTA COOKER WITH AUTOMATIC LOADING
If the probe does not detect the presence of water, the system will restore the correct level and after 15 sec. it will
disable the heating element: the alarm is indicated by a flashing red light
When the probe returns to detect the presence of water, the heating element is activated immediately and after 3 sec. the
automatic refilling is stopped
NOTE: the filling phase is monitored by the system through the TIME-OUT.
Slow refilling button
When the "slow refilling button" is active the system will fill the tank slowly so as to eliminate any foaming.
