81
Seat Belt Cleaning
The seat belts may be sponged with warm
water and should be allowed to air dry
naturally before use. Do not use chemical
cleaners and never attempt to bleach or
dye the webbing.
Take care to avoid the ingress of foreign
bodies into the buckle mechanism that
could affect the functionality of the latch.
There is no provision for disassembly.
WARNING
The seat belt should be replaced if the
webbing becomes frayed, contaminated
or damaged. Not checking or maintaining
seat belts can result in them not working
properly when needed. Check all the belts
regularly and have any problem corrected
immediately.
Footwell Cleaning
NOTICE:
Use only correctly secured Lotus
approved carpet mats in the footwells.
Floor coverings made from plastic or
other non-breathable materials may trap
moisture and initiate surface corrosion of
the footwell floors. Any damage caused
by the use of incorrect mats will not be
covered by the New Vehicle Warranty.
Sill Trims
Note that the sill trim covers will be sub-
jected to wear and tear during the normal
course of cabin access and may require
periodic replacement dependent on the
level of use and the owner’s preference.
Door Lock
It is recommended to periodically operate
the left hand exterior door key lock in order
to check and maintain its functionality,
should this ever be required. A special lock
spray grease will maintain smooth and
reliable operation. Your Lotus dealer will
be pleased to advise.
Be aware that any use of silicone based
general maintenance sprays can wash
out the grease required for mechanism
longevity.
‘Soft Feel’ Paint Finish
Special edition models may have specific
individual panels, or be completely painted
in a ‘soft feel’ matt paint finish.
Limited Warranty
Please refer to the separate Warranty
Booklet for specific terms and conditions
with regards panels painted in ‘soft feel’
matt paint.
Cleaning & Maintenance
The special matt paint finish applied to the
car requires special cleaning and mainte-
nance procedures to be followed.
Paint care products are listed below and
available to order from your Lotus dealer.
These should be the only products used on
the matt finish soft feel panels.
Lotus approved cleaning products:
Part Number Description
A000Z9101Z 3M/Sia fine abrasive pads
A000Z9018Z Go-Foam
A000Z9147Z Armor All Protectant solu-
tion
Cleaning Procedure
- Avoid washing the car in direct sunlight.
-
Use only automotive specific salt-free
detergents with clean water when wash-
ing.
- Thoroughly rinse all traces of detergent
from the body with clean (preferably de-
mineralised) water and dry with a clean
absorbent cloth before attempting to
remove any stubborn contamination with
specific Lotus approved cleaners.
-
Use only Lotus approved Sia fine (grey)
abrasive pads in conjunction with auto-
motive salt-free car shampoo in water to
remove any insect remains, tar spots and
SERVICING & MAINTENANCE
E132T0324JA Federal Evora 400 From SOP OHB English Language.indd 81
15/08/2018 14:47:29